Xtool Air Assist Unbox and Setup

 My Xtool Air Assist kit arrived today.  I unboxed it and set it up on my D1.  The kit has everything you need, the instructions are good.






I run the air line across the top of my "enclosure" leaving enough to let the head move around.  I would have liked a more flexible hose but it is fine for my install.



I have not tried using it yet but here is a video of the setup and the air pump is running.


I have to sort out the power cord routing and put a smaller board under the air pump.  It is interesting to note that there is no control on the air pump to vary pressure.  




Popular posts from this blog

Engraving Slate using the xTool D1 10w Laser

ProverXL 4030 in the Garage!