First project on my XTOOL D1 Laser

 After assembled the Laser I set it in place in my rack and loaded up LaserBox Basic.  The software connected to the laser and updated the firmware with ease.

 

I grabbed the logo for the preschool where my my wife teaches part time.  Brought it into LaserBox , resized it for a test scrap of plywood. I used the default settings :

Here is a picture right after the burn.

I cut the board down and sprayed it with some clear matte finish


 

I then mocked up my logo for the back of the work.  This is NOT final copy.




Then today I finished my logo and burned it on the scrap.  The image is 25 CM square, again default settings.  Ignore the partial burn above the logo as it was a test.








Comments

Popular posts from this blog

Engraving Slate using the xTool D1 10w Laser

ProverXL 4030 in the Garage!

Xtool Air Assist Unbox and Setup