When Four is Really Eight!

-


 We are mowing two yards every week or so.  My son and I have been cutting about every five to six days.  The first two times, we used both the 6AH batteries and part of a 5AH battery.  On the third time (#5 and #6), my son ran the mower, and he used all of that third 5AH battery.  

Last week we shared mowing, and we used both of the 6AH batteries and both a 4AH and 5AM batteries.  The grass is not any longer, it may be a bit thicker, but I feel the problem is the blade sharpness.  



Blades after six and eight cuttings

Before we mow again this week, I will sharpen the blades to see if I am right!

NOTE:  The mower is still cutting very evenly!

NOTE: With my Honda gas mower, I had to do the same thing, sharpen multiple times over the season.  The Honda did not cut well at all if it was dull.  





Comments

Post a Comment

Popular posts from this blog

Engraving Slate using the xTool D1 10w Laser

-
Image
 I used one slate to run two different power tests on a test tile.  One on each side.   From a tile burn Grid This one really helped me understand the range of marks we can make on a slate.  The following is the grid out of LightBurn and it was not as much help: There is quite a range of marking you can do.  I feel that it will allow some interesting effects.  I only needed one "tone for the project I am doing."   I did one test slate at 2000mm/min and 40% power for my 10W laser.  The design did not look right, so I changed the design slightly, and here is the finished project. Finished Slate Coaster Added Logo on the bottom I changed the speed to 1800mm/min and 40% power for the final project.  It slightly deepened the engrave.  The slate's top took about 16 minutes, and the bottom logo took 2 minutes. The setup is straightforward.  In Lightburn, I created two concentric square boxes on one layer that I do not burn.  These are for reference and alignment.  One is at 100m
Read more

Introducing the First Fourth Generation LED Laser Engraver: Roly Automation Lasermatic10

-
Image
What constitutes a Fourth Generation machine? Everything is included in the box! Industrial mechanical construction with little or no assembly required.   Improved safety with a full enclosure that does not let the raw laser light out.  Full cable management. Maintain  the small spot size for more precision Interior lighting to help with setup and observing the system in operation. Built-in camera for use with Lightburn. Exhaust fan built into the machine  Rotary system included Well-documented setup and operating instruction in the native language of the country being delivered to. Technical support directly from the manufacturer. Additional Thoughts There may need to be more than the small exhaust fans in these machines to overcome the stack effect in a house when trying to exhaust from a basement location. A powered Z-axis system for autofocus would be interesting. A little air from a variable air assist keeps the laser lens clean when engraving.  I manually manage the engraving and
Read more

ProverXL 4030 in the Garage!

-
Image
 I am planning to use the CNC to carve a lot of MDF.  The dust in the basement shop was too hard to control, so I built a workbench and put it on a machine cart to move it where I want in the garage. Here is an overview video:
Read more